if the neutral and ground of ups voltege are connected together in the source

if the neutral and ground of ups voltege are connected
together in the source itslef then why the voltege b/w
neutral and ground comes positive in some other destination
inspite of having earth pit. how can we mimmise this?

Question Posted / arjunchauhan47

1 Answers
3068 Views
MPL, I also Faced
E-Mail Answers

if the neutral and ground of ups voltege are connected together in the source itslef then why the ..

Answer / varatha

there maybe some earth resistance . we need to clear that

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

What is mean by analytical instrumentation?

0 Answers

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the

2 Answers

Calibration procedure for water rotameters

0 Answers HPCL,

cascade controller is feed back or feed forward or both

4 Answers

Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers Cisco,

how does pressure is converted into milli amps in pressure transmitter? plzzz explain practically

1 Answers rsystems,

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers

How much voltage we get between two wire of 4 to 20 ma output? Is this voltage up or down respectvice to 4 - 20 ma ?

9 Answers

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

0 Answers MSL, SRAAC,

How do we MEASURE OR CALCULATE VELOCITY used to calculate REYNOLDS NUMBER??

3 Answers

how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?

0 Answers Texas,

why is negative range given to measure the steam drum level

2 Answers Jindal,

For more Instrumentation Interview Questions Click Here