Answer / abhaynath

NO=XIC(EXAMINE IF CLOSED)
NC=XIO(EXAMINE IF OPEN)
NO IS DIRECTLY PROPORTIONAL TO INPUT LOGIC.
NC IS COMPLIMENT OF INPUT LOGIC.
i.e.
IF I/P=0 THEN LOGIC OF NO IS ALSO LOW(0).
IF I/P=1 THEN LOGIC OF NO IS ALSO HIGH(1).
ON THE OTHER HAND
IF I/P=0 THEN LOGIC OF NC IS HIGH(1).
IF I/P=1 THEN LOGIC OF NC IS LOW(0).
SINK MODULE ACCEPTS THE SIGNAL COMMING FROM THE SENSORS.
i.e.SIGNAL FLOWS FROM SENSOR TO MODULE.
SOURCE MODULE SENDS THE SIGNAL TO THE SENSORS.
i.e.SIGNAL FLOWS FROM MODULE TO SENSOR.

Answer / shalini

If the module is source +ve signal is shared, it gets -ve
from outside.

If its sink type then -ve signal is shared, it gets +ve
from the external source

If senor is source type then card shud be of sink type.
If sensor is sink then I/O card shud be source type.

Answer / mahip kaushal

this ia a basic and the most imp one too
NO MEANS NORMAL OPEN
NC MEANS NORMAL CLOSED
AS THE NAME SUGGEST NO IS A STATE 0 OR OFF IT IS BASICALLY
USED AS SWICH FOR EXAMPLE WHEN WE PUT ONN ANY ELECTRICAL
EUIPMENT LIKE BULB WE FOR THE SWITCH TO ONN POSTION I.E WE
TAKE THE SWITCH FROM 0 TO POSTION 1, FALSE TO TRUE.LIKE WISE
NC OPPOSITE TO NC INTIALLY IT IS IN HIGH STATE ,WE BASICALLY
USE NC IN PROGRAMING TO CUT SUPPLY AS WE FORCE IT FROM 1 TO
0 STATE

Answer / atul

sink means sensor to module and source means o/p module to o/p devices(like as motor,...etc)

What are the various methods for calculating the cost?

0 Answers  

---

How do I calculate 2% butane in a 1 foot cube at 29.66 CFM? It can either be a gas of pure butane or a liquid vapor.

1 Answers  

---

What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?

0 Answers  

---

What is process analysis?

0 Answers  

---

what is differance between PLC system and DCS system Proggramming. Give me answer. Thanks.

4 Answers   UltraTech,

---

WHAT IS THE FUNCTION OF BALANCE LEAK LINE IN BFP

2 Answers   Jindal,

---

what is mean pumps?

1 Answers  

---

Sir, we are manufacturer of splitter machine. we joint two knifes with welding electrode, BEST ARC, and ADOR, Grade E6013. but the time of welding the welded area comes to wear, what meterial(Electrode)is suitableto our requirement.this knife is press with Hydraulic operation.

0 Answers  

---

how a three wire proximity can be used in place of two wire proximity?

0 Answers   Samtel,

---

What is meant by improving?

11 Answers   CTS, TCS,

---

What is process planning? Mention different type of processes.

0 Answers  

---

axial displacements of the turbine. What could be the causes?♪ ♪

0 Answers  

---