Interested to Buy Any Domain ? << Click Here >> for more details...
Explain No & Nc concept used in allen bradley plc?
What is sink and sourse module?How you will use No,Nc
concept in sink and sourse module?
- 4 Answers
- 18510 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhaynath
NO=XIC(EXAMINE IF CLOSED)
NC=XIO(EXAMINE IF OPEN)
NO IS DIRECTLY PROPORTIONAL TO INPUT LOGIC.
NC IS COMPLIMENT OF INPUT LOGIC.
i.e.
IF I/P=0 THEN LOGIC OF NO IS ALSO LOW(0).
IF I/P=1 THEN LOGIC OF NO IS ALSO HIGH(1).
ON THE OTHER HAND
IF I/P=0 THEN LOGIC OF NC IS HIGH(1).
IF I/P=1 THEN LOGIC OF NC IS LOW(0).
SINK MODULE ACCEPTS THE SIGNAL COMMING FROM THE SENSORS.
i.e.SIGNAL FLOWS FROM SENSOR TO MODULE.
SOURCE MODULE SENDS THE SIGNAL TO THE SENSORS.
i.e.SIGNAL FLOWS FROM MODULE TO SENSOR.
| Is This Answer Correct ? | 31 Yes | 5 No |
Post New Answer View All Answers
What is plant organization?
What are the areas where I need to make improvement? (Please provide examples and suggestions for improvement).
what is dc injection braking?
Why the thermocouple is a transducer an rtd is not a transducer both taking heat as a input and give millivilt and ohms.
What is the difference between preventive-maintenance and periodic-maintenance?
what is a benifit to configure site to site vpn ?
how do you check pump impeller front clearance?
axial displacements of the turbine. What could be the causes?♪ ♪
What is difference between npn & pnp sensors?
What is the purpose of cost accounting?
plz send me l&t auestion papers. i have been called for written and interview industrial automation 2 yrs exper. send me on mail pal_deepak06@yahoo.com
What is purpose to use relay after digital output module?
pls sir can any body tell me the important questions of power plat operatoe my id is ali.ind85@yahoo.com plss
What is operation time?
what is load capacity of 11 cm cylinder bor 100kg. pressor?
