The higest value of thermal conductivity is expected for a.)
Solid ice b.) Melting ice c.) Water d.) Boiling water Give
the thermal conductivity value for each.
- 8 Answers
- 25420 Views
- BEL, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / arun pattanashetti
since thermal conductivity depends on the inter atomic atoms
,in solid atoms are very close to each other hence
transmission of energy is quite fast hence ans may be solid
ice.....
| Is This Answer Correct ? | 26 Yes | 0 No |
Answer / saikumar m.v
thermal conductivity of a material is known as the amount of heat flux dicharge trough that body .
as the conductivity of solid body is high the ans may be for solid ice.
| Is This Answer Correct ? | 18 Yes | 2 No |
Answer / chinna
answer pakka ice becoz it is a solid body,becoz k related to conduction only.conduction takes place in solid bodies in all cases,partially in liquids and gasses
| Is This Answer Correct ? | 8 Yes | 0 No |
Answer / imtiyaz
Ice at 0℃ = 2.18
Steam = 0.0184 - 0.0188
Water = 0.63
Boiling water = 0.2 - 0.4
So the answer is Ice
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / karthik
Well i m not sure but the answer might be Water... Since the Conductivity is determined by the Inter-atomic bond and i think Water has the strongest bonding among the three states... So Ans: Water
| Is This Answer Correct ? | 3 Yes | 21 No |
how many type of engine?
1.select bearing for flywheel to have a life of 5 years ? 2.select minimum diameter of the crank pin to work for at least 1 year? 3.select suitable belting to connect motor and pulley shaft(flywheel shaft)?
What do you understand by catenary cable ?
What is the relationship between cop of heating and cooling ?
what is the water hammering?
WHAT IS DIFFERENCE BETWEEN ANNEALING,TEMPERING AND NORMALIZING
Difference between QA&QC WIth Example
which type of thread is using for energy transfer..??
1 Answers California Institute of Technology (Caltech),
What causes turbocharger surging?
If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck
why rotory compressor is used in the gas turbine?
how can a turbo charger work in systemic concept?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
