all rector or exchanger have spherical/semispherical end why?

all rector or exchanger have spherical/semispherical end
why?

Question Posted / sumit5409

2 Answers
3134 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

all rector or exchanger have spherical/semispherical end why?..

Answer / chaitanya pithawa

because the pressure of the fluid is distributed.By making
this type of end,the force is divided into two.So the axial
force will reduce which will more safer.

Is This Answer Correct ?

0 Yes

0 No

all rector or exchanger have spherical/semispherical end why?..

Answer / julz

also because heat can be distributed equally on complete surface

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

Can some one please show me the design of a POT Bearing.

0 Answers General Motors GM, GM General Motors,

what is hammering of fluid?

2 Answers Bhel,

What instrument in a car measures its speed?

0 Answers

Why Air Conditioner capacity measured in Ton. Like 1.5ton

1 Answers

efficiency of diesel generator set:kwh x 3410 x 100/ fuel in ltrs x 0.87 x 2.2 x 19000. is it correct formula

0 Answers

Why combustion chamber is used in gas power plant cycle? What will happen if compressor output is directly provided to gas turbine?

3 Answers

What is function (in details) room sensor and tube or coil sensor in HVAC system?

0 Answers

Why are lng pipes curved?

0 Answers

Why is heat treatment required?

0 Answers

In which industrial process you will use centrifugal separator?

2 Answers Reliance,

Why rate of condensation is higher on a polished surface compared to rusty surface ?

0 Answers

I need BHEL apptitude questions

0 Answers Bhel,

For more Mechanical Engineering Interview Questions Click Here