what is rectifier?
Answers were Sorted based on User's Feedback
Answer / kaushal kumar garg
rectifier is elecronics device used for converting ac to dc.
it is consist of diode generaly. it remove negetive ac
cycle.after that signal is pass through filter to remove
those fluctuation in amplitude.
| Is This Answer Correct ? | 22 Yes | 1 No |
Answer / gaurang
Rectifier is an elctronics device used to convert AC to
pulsating DC.
we cant get directly dc voltage because there is some
ripple present in the circuit.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / velthe chipmaker
IT is used to convert ac to dc
mainly diode is used for rectification .if the sine wave is
in potion of +ve diode in forward conduction . -ve sine wave
is clipped .
.if the sine wave is in potion of -ve diode in revers bias
conduction . +ve sine wave is clipped .
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / ajay thomas
It employees one
or more diodes
to convert AC to
pulsate DC
voltage.
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / ashutosh dwivedi
rectifier is a combination of resitance & capcitance.it is use convert AC to DC.
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / amandeep singla
used for converting bipolar current into unipolar current
| Is This Answer Correct ? | 0 Yes | 2 No |
Answer / s.saravanan
Rectifier is a electronic circuit which is used to convert
the AC to DC.It is remove the AC cycle.It is does't have
frequency.
| Is This Answer Correct ? | 0 Yes | 5 No |
when was first developed dmrc.
What are the control strategies of chopper?
what is meant by modulation?
what is the operation of logic gates when no input is applied
hi friends.any one tell me pattern for mt exam for steel plant..plz plz plz..
d/f between fat32 and ntfs
draw the circuit diagram of a transistor frequency convertor using a tetrode transistor?
What is a transistor. Can u explain the basic operation of it??????
regarding bsnl jto examination,can i use the printout of application format mentioned in the advertisement.
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
What are the important ic technologies used?
why digital signals are preferred over analog in com?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)