I have observed a scanrio executed/elapsed time in 16 seconds and succeded, wh

I have observed a scanrio executed/elapsed time in 16
seconds and succeded, when I set the duraion to 'Run Until
Completion'.

Same scanrio is failed/Gradually exited/stopped, when I set
the time duration for 20 seconds (after the Ramp up has
been completed). Why it is haapedned.

Can anybody tell me the answer and solution also.

Thanks in advance.

Question Posted / chandra

2 Answers
7789 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I have observed a scanrio executed/elapsed time in 16 seconds and succeded, when I set the duraion..

Answer / sravan_tadikis

Very Simple :)

Depends on your run time settings if you have 10 iterations
then you have a setting for "RUN UNTI COMPLETION" THEN YOUR
SCENARIO WILL RUN UNTILL THE ITERATION COMPLETES. If not if
your scenario scenario setting is for run 20 munites then
it won't care about the number of iterations, it will run
only for 20 minutes.

It will execute in ths same manner.

Is This Answer Correct ?

6 Yes

0 No

I have observed a scanrio executed/elapsed time in 16 seconds and succeded, when I set the duraion..

Answer / preeti

when u go in for Run for 20 secs after Ramp-up,the
scenarioo is executed only upto 20 secs after the Ramp-up
is completed,so the scenario execution ceases immedietly
after 20 secs. In the actual process still some execution
has to take up,Since u want to terminate the scenario
imme.afetr 20 secs,the error will naturally occur

Is This Answer Correct ?

3 Yes

0 No

Post New Answer