Answer / tanmay maheshwari

Servo motors are used for testing faulty conditions as they
rotates only when an error signal comes to its control winding.
when an error(deviation from a rated speed) occurs in the
system, the control winding which is placed 90 degree to the
main winding generates a reverse torque hence regulating the
speed.

When we change the tap position of 10MVA transformer it suddenly tripped with Out of step indication and also with Static differential relay indication, Transformer Bucholz relay indn and Low oil level indication. Before 1 week the same problem occured by changing the tap position. but at that time only oltc bucholz relay activated. After testing the TxR Relay team & PET team cant find any solid reason. The values are ok also. So plz answer wat's the reason for this incident? anybody plz help.

3 Answers  

---

How magnetic balance test of single phase transformer is done,Especially in ESP transformer rectifier set.

2 Answers   Bhel,

---

why SCR use in power plant

1 Answers   Edison,

---

ABOUT AC GENARETORS AND MAINTANANCE AND TYPES OF GENARETORS

1 Answers  

---

How can we measure and monitor critical performance parameters of Diesel Generator Sets, both electrical and engine ?

3 Answers   Cologicx Systems,

---

How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter

2 Answers   GRB,

---

What do u understand voltage reg. of an alternator?

0 Answers   IOCL,

---

Wghat is D-curve MCBs

3 Answers   Indeco,

---

FOR WHICH FAULTS OR CONDITIONS DOES A TRANSFORMER DIFFERENTIAL PROTECTION DOES NOT OPERATE???

10 Answers  

---

Brief working principle of fluorcent tubelight,function of starter & choke.

3 Answers   Havells,

---

where does 22kv line starts

0 Answers   Eskom,

---

60 watts bulb and resistor home heater is connected in series and 230v is given to the circuit. The heater is giving some amount of heat. If instant of 60 watts bulb replace 100 watts bulb what will be the output of the heater?

2 Answers   NPCIL,

---