Answer / karthick

1.high alkalinity causes scale formation on the walls of
the heating surface so it reduces the heat transfer from
the surface to water.
2.the ph value is very difficult to be adjusted
3.eye and skin irritation
4.it affects the feed water treatment by poor filtration of
water

Answer / chanakyapitti

PH of water will indicate the characteristic of water. Normal water has ph value 7, weather it will decrease the water change as acid.If it will raise above 7 the water will change as base. Further raising of ph above 10.2 it will leads the caustic embitterment. This will form in inner surface of boiler tubes as scale which was heat resident. Due this scale the heat transfer rate will be decreased by increasing the layer thickness in the tube. Overheating of tube will occur. because of overheating tube will be damaged. so that boiler water PH should be with in limits between 9.6-10.5

What is the meaning of glanding ?

0 Answers   Goyal Group, TATA, Tata Motors,

---

• What is the overall structure of your job and how did you fit the structure?

1 Answers   Shell, Thermax,

---

What is the composition of Cast Iron ?

11 Answers   HAL, Wipro,

---

What is equivalent spring constant for spring in parallel?

3 Answers   Bhel,

---

Why required store to Factory?

0 Answers  

---

Can you explain axial play and radial play

1 Answers  

---

eligibity for TNPSC group 1 exam , age limit

0 Answers  

---

send me jindal tech round papers

0 Answers  

---

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers  

---

pls send RRB model questions papers for section engineering (Mechanical) for last 3 years exam models

0 Answers   RRB,

---

What is a vee used for on the vee block?

0 Answers  

---

What is long form of FIAT

4 Answers  

---