Answer Posted / chanakyapitti

PH of water will indicate the characteristic of water. Normal water has ph value 7, weather it will decrease the water change as acid.If it will raise above 7 the water will change as base. Further raising of ph above 10.2 it will leads the caustic embitterment. This will form in inner surface of boiler tubes as scale which was heat resident. Due this scale the heat transfer rate will be decreased by increasing the layer thickness in the tube. Overheating of tube will occur. because of overheating tube will be damaged. so that boiler water PH should be with in limits between 9.6-10.5

What are the requirements of a good fuel?

2066

---

why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?

2168

---

What are hydraulic and pneumatic machines?

1134

---

what is draft and draft loss?in a boiler,how is draft created?

2400

---

In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?

1122

---

Which parameter remains constant in a throttling process ?

1283

---

WHICH ONE IS PREFERRED, VERTICAL OR HORIZONTAL PUMP WITH COMPLETE TECHNICAL DETAILS

2427

---

Is IS 2062 different from ASTM A 36 or both are almost same

19883

---

What is the b check value of a 4bt engine

1653

---

hi this is ravi , i was short listed in hal assistant engineer, now im going for interview can anybody help how is the interview for mechanical stream very urgent if anybody knows forward to me my mail id i.ravibabu2@gmail.com

2283

---

What is the brain of computer?

1229

---

What is the specific heat of water?

1914

---

Define a turboprop engine?

1281

---

What are the causes of I.O. high temperature in a diesel engine?

1940

---

What are two essential conditions of perfect gas ?

1155

---