Answer / santhosh reddy

Due to the alkalinity, as water evaporates in the boiler,
it leads to the deposition of salts and these salts
deposited act as scales and prevent the transfer of heat to
the water in the tubes of the boiler as scales are bad
conductors of heat. This further increases the heat
consumption and the tube heating and thus lead to bending
of tubes due to overheating.

Answer / k.a.a.m

fouling , this is the result of using high alkaline water ,
then the consequence is : over heating the tubes then tube
failure.

Answer / shaunak kulkarni

Fast corrosion of boiler is caused by highly alkaline water,during steam generation,especially in those boilers which produce high pressure steam.

why...? turbo charger used in DG....?

7 Answers   Infosys,

---

i was selected in bhel et exam in mechanical engg discipline .can any one help me how to get prepare for interview

0 Answers   Bhel,

---

Why rate of condensation is higher on a polished surface compared to rusty surface ?

0 Answers  

---

if HR asks about, to tel us about automobile engineering wht should we answer him

2 Answers   Honda,

---

What happen when too much cylinder oil is injected in the working cylinder?

0 Answers   TVS,

---

Write the relation between EER , COP , SEER in airconditioning?

1 Answers   MGL,

---

what is the pressure and how to calculate it?

2 Answers   Virgo,

---

While selecting a diameter of 1 inch which pipe is better, ERW or Seamless ?? OR Out of ERW and Seamless which one gives good results for an impact force of 2700 N??

1 Answers  

---

what is the difference between dross and scale?

1 Answers   Hindalco,

---

the compression ratio of petrol engine is always less than c.r. of deseal engine why?

3 Answers  

---

What are topping and superposed turbines?

0 Answers  

---

Which pump is more efficient centrifugal pump or reciprocating pump?

0 Answers  

---