Answer / vinayak

Starting current basically dipends on Load. For Motor load
of Blower takes more time due to more time for blower load
(due to roubniest ) to its synchronous speed. where as in
pump achives synchonous speed at less time

Answer / vinod shinde

blowers has high inertia than pumps

If in a 3 phase supply if the load current is 200A what value of current the each phase R,Y & B will carry?

5 Answers  

---

DGs fuel and lube oil filters are not equal to one another.Why it is so.For example one MTU enginee fuel filter is one and lube oil filter-02nos other DGs are more.Please explain

1 Answers  

---

What is double delta conection in AC Motor? And can we done the double RPM of the motor by double delta conection?

1 Answers   vguard,

---

why 1.7Uo for HV cable Hi pot test?IE standard why?

0 Answers   ABB,

---

Why silica gel use?

1 Answers   PWD,

---

what is the working principle of induction motor

2 Answers  

---

In an ideal transformer no load primary current I0 A lags behind V1 by 90 degree B is in the phase with V1 C leads V1 by 90 degree D lags V1 by 45 degree

1 Answers  

---

Mention what are the types of semi-conductors?

0 Answers  

---

What is the usega of brking resistor? and how it will useful to Drive...?

3 Answers  

---

How to increase solar cell efficiency ?

1 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

A synchronous motor is operating at a leading power factor .if the applied voltage is decreases ,(the excitation remains constant ) ,the motor current a)increases b) decreases c)remains same d) none of these

2 Answers  

---