Explain why the Voltage drop will happen in 3 Phase line?

Question Posted / jagan

3 Answers
7829 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Explain why the Voltage drop will happen in 3 Phase line? ..

Answer / sunil ulange hit

Due to Corona Effect & Proximity Effect

Is This Answer Correct ?

4 Yes

1 No

Explain why the Voltage drop will happen in 3 Phase line? ..

Answer / mohamed

The system is supplying only to inductive loads.So the power
factor is low.Current increases in the system.remember
formula p=v*i and CU.LOSS The system is designed for certain
load demand and if the demand increases the the system could
not be able to supply the load.Increased current tends to
decrease the voltage to maintain power.So automatically
voltage drops in 3Ph system

Is This Answer Correct ?

2 Yes

0 No

Explain why the Voltage drop will happen in 3 Phase line? ..

Answer / zia abbas

due to low powe factor harmonic losses copper and iron
losses making the causes of voltage drop

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

There is 3phase power cable from 1 point to the other point which is 100m away. Two point equipped with power meter and recorded 1st point is 205kW while the 2nd is 202kW and each phase average carry 400amps. To calculate the resistance of the 3phase power cable, is the formula using will be P=I2R?

3 Answers

what is difference between electrical and electronics

2 Answers

hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz

0 Answers

what's mean by Transient stability analysis?

1 Answers

Can i connect all earth pits in ring system..., And wat IS 3043 says...please help me

1 Answers

How to connect a ELCB with contactor and relay ?

0 Answers

What are safety device in vcb and acb?

0 Answers IOCL, L Usine Fashion,

WE HAVE A PROBLEM THAT THE MAIN DRIVE OF OUR CEMENT MILL HAS AN EARTHING PROBLEM?TWO OF STATOR WINDINGS INSULATION HAS BEEN COLLAPSED DUE TO AGING PROBLEM.THE PHASES HAVE BEEN BYPASSED AND NOW THE LOAD HAS BEEN INCREASED.WE CAN'T REPLACE THE MOTOR.KINDLY HELP ME BY GIVING SUGGESTION THAT HOW TO MAINTAIN THE STARTING TORQUE AND CURRENT FOR HIGH LOADS.

1 Answers ACC,

What are the disadvantages of LT AVR over HT AVR?

1 Answers APTransco, Jindal, TNEB Tamil Nadu Electricity Board,

HOW DO YOU PROVE THE HIGH VOLTAGE CABLES OR BUSBAR IS DEAD EVEN AFTER IT IS DE ENERGISED

6 Answers

How is the gain affected by the introduction of feedback in a control system.

0 Answers GE,

How can we Run three phase motor when only single or two phase supply is available ??

3 Answers

For more Electrical Engineering Interview Questions Click Here