Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?
1 2304During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
2470
What valves are fitted in a four-stroke diesel engine?
Which type of DG need Netral Earthing?
Which are the top apps for you civil engineer?
Is critical speed temperature dependent or speed dependent or both?
Define blotch print?
Explain advantages of storage batteries
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
How to Make relay co ordination chart for a Electrical power distribution of a plant
I want previous rrb enteranse exam papers in section engineer. please send that papers to my id rohit_nist@yahoo.co.in
what is difference between fluidity and workability also how palsticizer works
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
how is control wiring coding is done in a CRP panel ?
What are you going to inspect or check when you open the crankcase?
thermal engineering
I want to apply for Asst.vehicle inspector,i would like to know the requirements and the syllabus.. if any body know that please mai me.. naany4u@rediffmail.com please friends