A remote user needs a static IP address to support a specific application.Which remote access VPN addressing technique supports this ?
2 7257Which two statements correctly identify considerations to take into account when deciding on campus QoS Design elements ?
1 51895. Which Two Settings must be configured in order to use the GUI to configure Call Admission Control with voice Applications
1 4268A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?
2 6164An user from the LAN is able to ping the default gateway of the router and other sites in the internet. but not able to ping only the google site, no acc list configured and no firewall and no problem with DNS atall. What may be the problem with router?
8 11800what is standard and extended acess list? what are the commands for extended and acess list?
HCL,
3 8502If i connect two routers through ethernet cable and serial cable then which has high speed and which is better among two?
10 15073Where shall i do CCNA cour??. can i do CCNA at home if yes then where shall i get CCNA book or simmulator.or if not then plz reff. me any good center in delhi
1 4654
What are the possible ways of data transmission in ccna?
Is hub intelligent device?
Which mode called privilege mode?
What is the difference between rip and igrp?
What are 10base2, 10base5 and 10baset ethernet lans?
What is the frame relay?
Which defined peer ip address an local subnet belong to crete?
Mention what is dhcp?
Why ip address called logical address?
What is ping utility?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
What is the maximum request timer?
What are the advantages of a layered model in the networking industry?
What is the default size of frame?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?