Answer Posted / pradeep kumar

Raid 1 used for mirroring .

Minimum 2 disk required in order to configure the Raid 1.

Its one of the best solution for the fault tolerance of the
failed disks.

You can remove the failed disk and add a fresh disk which
will synchronize automatically.

RAID 1 specially for mirroring the disk in order to avoid
the downtime bcoz of failure of HARD DISK.

Regards,
Pradeep

VLAN tagging/un-tagging process –where and when it happens?

2204

---

How dynamic host configuration protocol aid in network administration?

1229

---

diff between /etc/inetd and smf?

1969

---

How to delete software errors? What is that?

2079

---

how i can Design a client–server network with two servers operating at 100Base- T Fast Ethernet speed and the clients operating at regular 10Base-T Ethernet speed using a 10/100 Mbps NIC. The hub is located in a wiring closet, but the servers and clients are not. Assume that a satisfactory performance is achieved at 40% utilization of the LAN.

2692

---

What are the drawbacks of implementing a ring topology?

1157

---

What is arp main job?

1095

---

main roll of network administrator

1979

---

Explain how to identify the ip class of a given ip address?

1128

---

Tell me when troubleshooting computer network problems, what common hardware-related problems can occur?

1252

---

Purpose of TTL. How it gets modified.

2168

---

What is 10base-t?

1255

---

how to set tunneling in putty when any portno blocked from firewall to use resources with that portno like ssh 22

2511

---

How do you remove Meta only for the root slice? Remaining slices should run under Meta?

2610

---

whenever we give #metastat cmd in svm, it display output "need to maintain" state, what u do?

2028

---