In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
- 19 Answers
- 24210 Views
- Essar, GAIL, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / milan
secondary side winding turns is designed for 200 volts. If
we give 415v the secondary side winding turns will not
sustain the voltage . For which insulation and winding both
will damage .If we give 415v to secondary the primary will
get 816.125v
| Is This Answer Correct ? | 19 Yes | 3 No |
Post New Answer View All Answers
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
Air refrigeration cycle works on the
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
Ac generato how produce power I need for camplet defination
Define ohm’s law for a.c (alternating current)?
1.what is mean by 8/20 micro sec waveshape
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
Is any generator is developed which is operated with out diesal or other expensive source?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
harmonics filter
What is Harmonics how it is produced and what is the method to control the same
what is circuit recombiner and how it is different from circuit breaker
