how to calculate no. of earthing pits and their diamensions?
no. of lightning arrester rods which are required to
protect a building of 35 mtr and we calculate?
- 5 Answers
- 26619 Views
- Dharampal Premchand Limited, FlowMore, Hindustan Zinc, Ispat, Maheshwary Ispat, NDDB, Siemens, I also Faced
- E-Mail Answers
Answer Posted / ramasubramanian.ganesan
Normally the area which is covered by a lighting arrester
calculated on the basis of PYTHAGAROUS statement.
In a right angled triangle, the sum of sqr.root of the
adjacent and opposite sides is equal to the sqr root of the
third side.
In the question asked the height is 35 meters. based on the
above we have to calculate the required datas.
| Is This Answer Correct ? | 15 Yes | 34 No |
Post New Answer View All Answers
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is high and low cut off voltage of BB and DG at SPS????????
two way ckt diagram can be drawn by how many ways? give diagram
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
what are the basic insulation levels & what its Unit
If we want to change a contactor of faulty one what are the conditions want to fullfil
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
what is conductor constant of raccun conductor
what are the possible reaons & remedies if resistance of NGR getting heat up
importance of reactive power management
what is the formula of starting current of 3phase and 1 phase motor???
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
Q: How to calculate Transformer losses , tell us by Formula.
what happens if dc supply is given and the remedies for it.
