Interested to Buy Any Domain ? << Click Here >> for more details...
what is form factor.and rms value..
- 1 Answers
- 5034 Views
- IIM, Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / k.sushma
The ratio of r.m.s value to the average value of an ac is know
as form factor.
Form factor=r.m.s value/average value
R.M.S value =maximum value/peak factor
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the meaning of 5% droop or 7% droop in AVR?
what is the meaning of vcc
How cable from Kit-Kat to main switch, from starter to motor are designed?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
What does the term supermesh means?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
what ispositive, negative, zero sequence impedence?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
ult of expression 'document.FrmQF.myem
Phase control and integral control are used for?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Define what is the function of anti-pumping in circuit breaker?
what is W.T?specify the acceptable range?
