I have one problem for masoneilan displacer type LT.I give some imformation in data shéet given for liquid level range 0 to 600 mm and sg .955 problem is 0% is ok 25%(23%) or 50%(48%)and 75%(73%) and 100% is ok this is up value and down value all ok so please halpe me
- 2 Answers
- 4098 Views
- Hyundai, TATA, I also Faced
- E-Mail Answers
Answer Posted / muhammad nasarullah khan
Hi Dear.
As you mentioned here taht transmitter's out put 0% and 100% (SPAN) is ok, but inbetween outputs having errror. So you are facing withe " LINEARITY PROBLEM "means out put is not linear , and that always should be linear. so go to linearity section by HART communicator ,hopefully I have answered your question.Regards
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
Draw symbols of the following :
what is interlock system and why we use of this?
What is the difference between uv and ir scanners? and what is the workig principle of both
what is dc moter.
NSV type probe stands for
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
can we create an interrupt in plc through scada?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
Identification of ss fittings, pilot valves, relief valve.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
How to fix back the valve actuator stem
how do u calibrate the vacuum transmitter if it shows more reading
