Interested to Buy Any Domain ? << Click Here >> for more details...
Telecom BSS related ques:
For cascaded 1800 BTS with master 900 BTS,if 900 master BTS
is down for its own equipment fault,cascaded slave 1800 BTS
gets down/stop carrying traffic without any fault as BCCH
and other controllong channels are in master 900 BTS.Is
there any technology/system to turn the slave 1800 BTS to a
single 1800 BTS autometcally when 900 master BTS is down
for its own equipment fault???It is possible to make the
slave 1800 BTS single live BTS manually.But I want to know
the autometic system/process.if there is any....if not
available, how can we generate the system??
- 3 Answers
- 16218 Views
- Ericsson, Grameen Phone, Nokia, TATA, Telecom, I also Faced
- E-Mail Answers
Answer Posted / ladiesman217
Might be using dual E1 in that case will be much more helpful.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,
How will you determine what frequency the device has without using oscilloscope?
am going 2 write railway exam 4 d post of section engineer..i wnt 2 knw abt d que pattern n d previous year que papers
difference between transient & Steady state response?
hi i wnt to know the general hr questions aked in wipro with answers
explain the output of the lexical analyser is
What is the conductivity of perfect dielectric?
How is cad used with electronics? Give example.
What is the construction of a solar cell? How is emf generated?
What are the advantages of single phase bridge converter over single phase mid-point converter?
Explain the difference between masking and non-masking?
How the FM 200 System is work? Just give me a reply about the Fire Incident and then Suppression by FM 200 step by step? Regards, ZahIR Uddin Babar For, BAFFESCO
What is monolithic ic?
What is meant by phase controlled rectifier?
is there any good institute in mumbai that provides good Automation courses ?
