Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rcsp2689
Inprocess loop measuring Ends can be calibrated . ie., Sensors.. Where else Actuators are Final contol element / Output devices.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how to calculate the total flow in square root
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
how to measure draft pressure in transmitter pl. give its single line digram
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is the purpose of the analyzer in petrochemical plant?
where proximity sensor installed on tank in loading arm application
How flow can be measured with dp?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
How digital input and digital output 's are working in dcs
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
how to design orifice plate?what is the equation?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
what is a half wave, full wave, and bridge rectifer.
