Interested to Buy Any Domain ? << Click Here >> for more details...
What is AVR in Turbo generator in Thermal power plant?
- 5 Answers
- 24313 Views
- Thermax, I also Faced
- E-Mail Answers
Answer Posted / d oldham
The synchronous generators used do not naturally operate at
any particular voltage but the voltage can be adjusted by
manually setting the excitation. However as soon as any
load is put on the generator a different value of
excitation is required. The AVR automatically makes the
necessary adjustment by closed loop control to keep the
generator voltage constant. The operator can manually
adjust the AVR reference to allow connection to a power
system. Once connected to a large power system the AVR
setting determines the reactive power load kVAR on the
generator. A high setting exports kVAR (lagging power
factor) and a low setting imports kVAR (leading power
factor).
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
how does commutator convert a.c to d.c?
How is magnetic leakage reduced?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
how we can calculate chiller required ampear?
write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
number of I/O devices in siemense plc
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
what is EIB lighting control system? what is the advantages of this system?
what is the max. acceptable leakage current in 33kv bus bar
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
State the methods of improving power factor?
