Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen when we connect 2 bulbs in series between 2
phases
- 7 Answers
- 16951 Views
- Pepsi, PowerTech, I also Faced
- E-Mail Answers
Answer Posted / ghanshyam singh
well dear, the glow of bulb will depend upon the phase angle between the phases.
if there is any phase difference, as generally happens in case of three phase system, then the bulb will glow, with the resultant frequency.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
How to calculate cable rating for 3 phase supply?
Define damping ratio.
what the principle of sincroscope?how it works?when it needed?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
What are IR values and what it should be for coil and for insulator
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
Why using synchronising methed in DG's sets?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
What are the effects of adding a zero to a system?
