why do we generate sinusoidal ac?can we generate some other
waveforms by alternators?
- 11 Answers
- 15429 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / p.senthil kumaar
If You place Square shape Alternator, the wave become Square.
If circle produce sin wave.
If triangle it produce triangular wave.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the main significances of root locus?
the problem faced on star or delta winding connection??
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
why does connected a indutor with mnsformeretering core of current transformer ?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
low frequency protection why recomend?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How phase displacement change in the over current relay coils.
Plz tell me how we can find that particular company has vacancy or not
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
In CTs tan delta point should be earthed , what is the reason behind it?
what shoud be strength and weakness to impress interviewer????????
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
what is 3rd Harmonics? how it is generated in alternator
