Interested to Buy Any Domain ? << Click Here >> for more details...
What is purpose to use relay after digital output module?
Why normally we don't use relay for digital input module?
- 3 Answers
- 8486 Views
- Siemens, Sofcon, I also Faced
- E-Mail Answers
Answer Posted / senthil
Digital O/P module used as interface relay(isolation
circuit) between controller to the load. we cannot connect
the controller output to the load side, which may required
high amps to energise a contactor coil or etc.,In this way
controller is not get loaded.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
what is load capacity of 11 cm cylinder bor 100kg. pressor?
reversing of each word in the string
how do you check pump impeller front clearance?
What is process analysis?
What is quality management system?
i have one air blow heater , coiled heater is in side hollow ceramic tube and passing the air and other end hot air is going out, to control the hot air where i should fix up a THERMOCOUPLE on the heater or on the out let of hot air terminal which is the best way
What is load line in control valve?
How three wire proximity can be used in place of two wire proximity?
give comparison of three wire & two wire sensors.
Write a C++ code that print the largest two among three numbers
what is the power supply of 4 wire transmitter?
What is purpose to use relay after digital output module?
How we install and terminate the wire of pressure transmitter and temprature transmitter. Give full explanation.
Why we use pneumatic instrument.
What is refrigeration cycle of HVAC .
