Why we choose 400kv,220kv,132kv,66kv,33kv transmission
voltages for transmitting power. Why not other voltage
levels.
- 21 Answers
- 57256 Views
- College School Exams Tests, HC, HCL, Jaypee, JPMorgan Chase, I also Faced
- E-Mail Answers
Answer Posted / rahul kumar
because at high level transmitting power we woud get less
insulation cost so generation voltage is always taken in
multiple of 1.1,
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
physical identification of HT & LT panel
What will be in Mahagenco Trade Test Exam? I want to know the same.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Why increase in current leads to increase in conductor temperature?
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
what is the minimum voltage require to injure our body?
How capacitor improves pf
how we can explain arc heatng?
Percentage losses in power generation?
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
What does the term power factor shows?
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
how ct burden,magnetising current,ratio and knee point voltage are related & derived
