why delta delta connection generally not use in transformer
- 4 Answers
- 8148 Views
- Lanco, I also Faced
- E-Mail Answers
Answer Posted / nitin bhoraokar , power plant
In delta - delta type winding connections,protection against
earth fault is difficult as zero sequence current will get
circulating in windings itself & will not flow to ground.
Hence transformer isolation on earth fault is
hectic.Stability against E/F will get lost.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What was your role in the silicon evaluation/product ramp? What tools did you use?
Define unilateral circuit?
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
What is the type of feedback used in an op- amp schmitt trigger?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
explanation of mesh bus bars
How can you sized or estimate the ligthning arrester current rating?
What is the limitation of kirchoffs law?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
how ceiling fan worked?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
