why delta delta connection generally not use in transformer
Answer Posted / abc
Generally Transformer at generating station and at load
centres can not be used in delta-delta fashion due to non
availability of neutral point.
But if load is delta connected or in case of transmission
lines at both side then delta delta fashion can be used.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is Control & Relay Panel? And Remote Control Center?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
Is there any guideline say about display of earthing value near to earth pit
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
state basic meaning of 'INDUSTIAL AUTOMATION'?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to calculate
how ceiling fan worked?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
What type interview questions ask in Electrical technicians
While testing a ZCT what parameters have to check or measure?
What happens if we connect a single phase energy meter in reverse polarity.
Swg formulae