Interested to Buy Any Domain ? << Click Here >> for more details...
if we give DC suply to the AC motor what hapen
- 5 Answers
- 8493 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / r.suresh babu
The AC motors are haveing a less resistance so,it will be
operates in only AC supply.In case of by giving DC supply
field windig is burn,after that motor is damaged.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
briefly explain principle of resistance welding
WHAT IS DEAD END IN PROTECTION?
How to calculate the heat load for a electrical room
How earthing of switchgear system to be done.
Write down the brushes of a de machine.
what is gridrotor resistance starter
how could we know the size of cable by physical view?
what is tri state logic gate
What is the basic rule for block diagram reduction technique?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What is Bolted fault?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
What is Phase margin?
Define average demand?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
