What is maximum demand?How can we caluclate it?
- 3 Answers
- 5094 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / natha
on the basis of load curve it is calculated.if suppose you have to find the max demand(md)of ur house plot time on x axis units consumed on y axis.you get supppose 2units 6am 30 7am 42 8am 5 9am.....till midnight.then ur max demand is 42units.all other factors such as load factor,diversity factor can be found.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
how to calculate transformer turn primary & secondary side 11kv to 420v
Can clean earth cable be considered as low current cable
describe the phenomena of vacuum interruption in C.B
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
What is meant by stator? What is meant by rotor?
What is the exact formula for one weber of magnetic flux?
What is Control & Relay Panel? And Remote Control Center?
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
What is q factor?
