Interested to Buy Any Domain ? << Click Here >> for more details...
if a damaged 500kva transformer with %impedance 2.6 is
replaced by two transformers of 250Kva with different %
impedance will they be able to catter the load. what will
be the ratio of load on the two transformers if the %
impedance is in the ratio 1:2
- 2 Answers
- 4718 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / aamod tripathi
This should not be done ideally (Parallel operation not
permitted) . However the load can be distributed exclusively
and independently on each transformer (Each Transformer
connected to indivisual (incomer) feeder and independent
loads(outgoing))
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
what will happen if OLR CT in all phases are short circuted
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What is the Current equation in series RLC circuits.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what is difference between cpp electrical system and refinery electrical system
please send previous exams question papers
ult of expression 'document.FrmQF.myem
what is KSR type transmission tower? What is LSR type transmission tower?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
What are the main advantages of bode plot?
HOW TO CALCULATE EARTHING SIZING?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
how to enter inverter parameter? without manaual?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
