Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashish namdev, bina refinery
interface LT use in that application where two liquid mixed
in a tank. For calibration interface type LT these
instructions to be follows -
1. set upper & lower range.
2. set upper & lower density.
3. after then put weight according calibration data sheet
& note readings at every sample weights.
4. If the output have some error then give lower trim & upper
trim command to LT with weight at 0% & 100%.
5. recheck all value at different weights.
this LT work upon bouncy principal. which liquid will have
high density that will be make reference to LT.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
what is metal of piston ring
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
How to Calibrate Flammable gas detector in field
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
can you provide me full detail about instrumentation in ONGC??
How many interlocks at turbine? Plz explain briefly
What are different types of cable?
Define cryogenic?
