Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohammed abbas
Itis depend upon the sensitivity of the thermocouple used
because the different combination of alloy is having
diffrent sensitivity like.
1,copper/contantan =0.039mv/deg
25deg c=0.915
2,Iron/contantan=0.52mv/deg
25deg c=13mv
3,Platinum/rhodium=.05mv/deg
25deg c=1.25mv
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
pls give me presant awerness quistion and answer in my emailid.
what will the sending unit in the fuel gauge utilizes?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
Capacitance, resistance ( colour coding ), parallel & series circuits.
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
How to convert Differential pressure to flow in TPH
What is three element drum level control system why its better than single element?
Explain Gas Turbine startup and shutdown sequences
why fuse block is not used for AI signal?
Explain operation of Haskel pump.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what are the steps I have to deal with?
you are on site,the plant trips,you are approached by operations,what do you do?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
what is difference between fork type and capacitance type level switch. where it is using
