why is the rating of transformer done in kva and not in kw.
Answer Posted / ram
simply, transformer is not itself aload. it only step ups
or steps down the voltage without changing the supply
frequency, the power factor depends upon the load supplied
by the transformer.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why different series of vfds (like allenbradley)are used in industry ?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
why connecting surge unit in contactor coil
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
boiler is running in rankine cycle and deisel generator is....?
what is the function of statics switch in ups and tell me parts
What is VCB? where it is installed at SP. What is SP?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
distribution is maximum done by a)radial b)network c) parallel d)b & c
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
HOW TO CALCULATE EARTHING SIZING?
What is vacuum circuit breaker.define with cause and where be use it device?
How to decide and select the different earthing wire size for the different types of earthing
why we are using earth pit in sub stations.?