We use ungrounded DC system (220V/110V) for control and
protection system in substations etc. Suppose we have long
2 core DC cables running from our DCDB in control room to
the load (length of around 2 to 3 km). Do we need to
protect these long DC cables from earth leakages or not? If
yes how?
Answer Posted / sanjay
You can use online Insulation Monitor Bender Germany make
products for above requirement you can also see website for
more details: www.bender.org many Steel Plant, Substation
are using Bender products same applicaton.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
how we can calculate 2 phase welding transformer rating or total power?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Alternator rotor earth fault relay circuit
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
Which level of the Transformer oil got dielectric strengh? And why?
what is inter connected dc generator?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
What is resistance of 50meters, 16sq.mm, single core copper cable?
Why do we use copper cable for HT Supply and why not Aluminium?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
how does a liquid starter reduce the starting currents?