Interested to Buy Any Domain ? << Click Here >> for more details...
Dear Sir/Madam,
I am attending an interview for ETs in BHEL. I have cleared
my written test under Electronics (Instrumentation). This
is the first time I am appearing for an interview. Can any
one who has attended the interview earlier give me a clue
to face the interview.
With regards
Sindhu
- 2 Answers
- 6202 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / matrix controls c.subramaniam
Sindhu,
For everyone everything is first time first only,
No body has experienced anything before or while birth so
be bold and confident be through in your basics dont trell
wrong answer if you dont know say dont know, try to be
smart as this age people.all the best and god bless you,.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
how to calibrate corollaries (Mass flow meter)?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
How to calibrate the flow transmitter
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Explain pH, Conductivity.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
What are advantages and disadvantage of the ac supply load cell?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
What is instrumentation instrumentation engineering?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
