11KW Delta motor is taking about 44Amps in star and goes
upto 70Amps in delta and trips OFF. The rated current is
26Amps. Application is for the blower. The motor takes ( no
load without coupling impller ) only 2.5A and 5Amps in star
& delta starter test.Need to know why its taking high
current.
Answer Posted / boby
I think there is something wronng with imppller coupling
it alingment could be out. Because no load current of
motor is ok . So check the coupling alignment , motor
bearing and connection of input cable at main source.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to test IR testing & magnetic balance test
Why different Pressure switch used in marine boiler water circulation system
What are the types of class b amplifier?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
What is Instantaneous Earth fault relay,how will work
Why the field rheostat is adjusted such that the voltmeter reads 380V
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
Do u know any one? how to find out in motor rated amps? formula?
How is the speed of a DC shunt motor related to the armature current?
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
What are the three types of compensators?
What is meant by derating factor?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
electrical knowelge