What is the function of accumulator?
Answer Posted / eng/khalid abdo
A hydraulic accumulator is an energy storage device. It is a
pressure storage reservoir in which a non-compressible
hydraulic fluid is held under pressure by an external
source. That external source can be a spring, a raised
weight, or a compressed gas. The main reasons that an
accumulator is used in a hydraulic system are so that the
pump doesn't need to be so large to cope with extremes of
demand, so that the supply circuit can respond more quickly
to any temporary demand and to smooth pulsations.
Is This Answer Correct ? | 103 Yes | 18 No |
Post New Answer View All Answers
Are all the bits of flag register used in 8051?
The answer to the above question is breaking the combinational circuit and pipelining it. What will be affected if you do this?
Give example of bit address and byte address?
What is meant by cross-compiler?
Why is the address bus in the 8085 tri-stated and unidirectional?
What is the position of the stack pointer after the push instruction?
Explain what type of architecture is used in 8085 microprocessor?
What is the purpose of data moving instructions? Name any two such instructions?
Can you tell how many pins are there in 8085 Microprocessor?
Byte wise what are the lengths of call and ret instructions?
What are the general purpose registers in 8085?
Why do we use two ground pins in the pin diagram of 8086?
In 8085 name the 16 bit registers?
Define what the sop does with the help of an example.
Which interrupt has highest priority in microcontroller ?