Interested to Buy Any Domain ? << Click Here >> for more details...
Why is copper a better conductor of electricity than
aluminium?
- 5 Answers
- 10570 Views
- AES, I also Faced
- E-Mail Answers
Answer Posted / therion
Because copper has more free electrons than aluminium but
not as much as gold or silver.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
describe the fully control circuit diagram of ac drives
how can we change the phase angle b/w two phase?
what is the difference between oil surge relay and buchholz relay.
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
How work of capacitor in dc supply...???
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
what is meant by carrier aided trip protection in transmission line
how give earthing conection to household equipment?
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
can anyone give an idea about dia calculation in cold rolling mill
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
