11KW Delta motor is taking about 44Amps in star and goes
upto 70Amps in delta and trips OFF. The rated current is
26Amps. Application is for the blower. The motor takes ( no
load without coupling impller ) only 2.5A and 5Amps in star
& delta starter test.Need to know why its taking high
current.
- 10 Answers
- 16920 Views
- Pfizer, I also Faced
- E-Mail Answers
Answer Posted / suraj_ojha
I am agree with mr.rajendern there is some mistake is in
their control wiring of starter.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
what is under coal gassification?
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
Why reactors use before incoming of ac vvfd drive?
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
Control wiring of a dol starter for forward and backward
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
State angle criterion.
for a 400kv t/m line with 10 ampere current will corona occur?
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What is difference between start imitation and start interlock for 3 phase motor protection ?
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
why are the maintaine power factor and how can this control and this is how work.
