Interested to Buy Any Domain ? << Click Here >> for more details...
why is the rating of transformer done in kva and not in kw.
- 21 Answers
- 34345 Views
- Honeywell, Satyam, I also Faced
- E-Mail Answers
Answer Posted / beau
because transformer capacity takes care of both real power
consumed by resistive loads and reactive power in inductive
and capacitive loads such as motors and the transformer's
windings inductive reactance(Apparent power KVA).
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
can u please mail me the syllabus for GET exam for damodar valley corporation?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
how can we calculate the ratio of caustic soda and water in lrs.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
What was your role in the silicon evaluation/product ramp? What tools did you use?
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
distribution is maximum done by a)radial b)network c) parallel d)b & c
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
What are locations arc protection relay is fixed.
How to synchronization will be done between two DGs ?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
explain the types of drives
