Interested to Buy Any Domain ? << Click Here >> for more details...
where do you give the 4-20 ma i/p in a MIL control valve?
- 3 Answers
- 9686 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / sagar gadag hiranyakeshi suga
we give 4 to 20 ma i/p in positioner(in built
current/pressure transduser)
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
What is hp & mp seperator .& what is its working principle ?
why using negative supply for bentley nevada vibration system ?
How to calibrate capillary type level transmitter
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
Explain the burnout feature.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
give me all the details about the interview and which type of question being asked
whats the abbreviation of IOP? is it instrument of power or input open problem?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
