11KW Delta motor is taking about 44Amps in star and goes
upto 70Amps in delta and trips OFF. The rated current is
26Amps. Application is for the blower. The motor takes ( no
load without coupling impller ) only 2.5A and 5Amps in star
& delta starter test.Need to know why its taking high
current.
- 10 Answers
- 16915 Views
- Pfizer, I also Faced
- E-Mail Answers
Answer Posted / rajendran
The motor takes very less current at no load than the
normal and when it is loaded it is taking the obnormal
currents even in delta operating mode....
it seems there must be a problem in the connections or in
the supply voltage of the mains or improper impeller
arrangement causing very high load.
probably there may be a problem in the connections only...
check the connections
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
how to carried out tan delta test in 11 KV alternator ?
What is the different between digital phase converter and ordinary phase converter?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
What products have you designed which have entered high volume production?
what are carbondioxide and dcp used in fire extinguishers
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
How to convert 2 phase to 3 phase electricpower in induction moter?
How to do maintenance of transformer feeder.
what are types of encoder
How isolater function when installed inelectrical 440V wiring
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
Why does amplifier gain reduce?
