Interested to Buy Any Domain ? << Click Here >> for more details...
what is the role of proportional in process control?
- 6 Answers
- 10838 Views
- OGDCL, Trident, I also Faced
- E-Mail Answers
Answer Posted / dinesh
proportional control is used to linear
increase(relationship) with the controlled variable and to
the final control element
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how to measure oxygen which methods are using?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How flow can be measured with dp?
What are the interlocks we have to check during the start up of LP/HP compressor?
How oil line flow measured?eplain about instruments used and working principle?
can we create an interrupt in plc through scada?
What is the use of control cable?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
how to calibrate Necleuonic level transmitter.?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How is automatic reference junction compensation carried out in temperature recorders?
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
Explain PID controller tuning & any one method used for it.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
