Interested to Buy Any Domain ? << Click Here >> for more details...
what is the role of proportional in process control?
- 6 Answers
- 11072 Views
- OGDCL, Trident, I also Faced
- E-Mail Answers
Answer Posted / rajesh
Normally In PID Controller Proportional gain and integral
time is important parameters
in Process control we are using several parameters so we
maintain a pertucular level of the system proportional is
used.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Operational amplifiers
what about your moleg in pogrees with company
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
How to interfacing microcontroller with a DC motor
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
why using negative supply for bentley nevada vibration system ?
what is the different between deflection type measurement and null type measurement in RTD?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
