how to calculate circuit breaker capacity
- 6 Answers
- 72873 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / nighot jagdish
Rated symmetrical breaking current in kA would be Fault
MVA*1000/(1.732x Voltage in kV
| Is This Answer Correct ? | 50 Yes | 19 No |
Post New Answer View All Answers
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
What happens if we connect a single phase energy meter in reverse polarity.
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
wat is d diffr btw shunt coil and trip coil in VCB?
where rlc series ckt used?
I am an American living in Vietnam and I have recently gotten a refrigerator from Japan and it is rated for 100 vac, but the power here is 220 so I bought a voltage stabilizer it has a 1 kva output rating. Can you please tell me what the amperage is? I'm confused and without a working fridge.
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
What is difference between YNyn0 and YNyn ??
how calculate gd2 of ht motors
How many points does a Circuit can have?
