Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sanjaymaven
i follow your above procedure
i use 0-30 psi pressure gauge
when i feed 4 mA gauge show 3 psi, gradually i increase mA
, simontaneously pressure increase.At 10 mA gauge shows maxm
20 psi. i little adjust the range screw but nochange on
gauge. now what will i do .please sujest
| Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
Explain about the leakage class of the control valves
Explain the working principle of lvdt?
use of split range ? where it is used ? in which control loop it is used ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
what is interface level and how it is calibrate?
if in a level tx height is given, how u calculate the ranges of the tx?
what will the sending unit in the fuel gauge utilizes?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
how to design orifice plate?what is the equation?
Difference between dcs and plc including date processing and architecture.
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
field bus transmitter calibration procedure tell me
