Give the selection criteria of a 3 Phase transformer for
industrial purposes ?
- 5 Answers
- 10444 Views
- NDDB, TATA, I also Faced
- E-Mail Answers
Answer Posted / tauseef tarique, engineer(e)
For the selection for the transformer first calculate the
total load and then apply the diversity factor.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
Why can't we parallel Voltage transformer secondary circuits?
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How cable from Kit-Kat to main switch, from starter to motor are designed?
Why is better to have a minimum ceiling voltage of 250% than 160%?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
what is the internal working of star delta starter
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
What is transmittance?
what is meaning of bus riser
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
what is the relative size of single and three phase?
In a single how much maximum current and watts using
A cotter joint is generally used to transmit
