why is the rating of transformer done in kva and not in kw.
Answer Posted / dhaval
as core loss depend on applied voltage and copper loss
depend upon the applied current so the transformer is
rating in kva not in kw
Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
How to calculate cable size by using load.?? Any formula...
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated
Define open loop control system.
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
how to find the Motor,s insulation Power?
please explain how to do 'pole drop test' on generator?
sugest any typical project ?
why we r not earthed Control cable of C.T. terminals
why the pf of semiconductor device is improved the electrical devices
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.